Receiver 1 channel 12v mini with 1 control

1 channel receiver (1 relay output) + 1 command

Operating voltage: 12VDC

3 working modes: Fixed Bistable / Momentary / Latch

Fixed, Bistable (Switch Type): (Press Button A> ON; Press A again -> OFF)

Momentary: (Press and hold button A -> ON; Release-> OFF)

Relay: 10A 125VAC / 250VAC 10A / 10A 30VDC / 28VDC 10A

Size (LxWxH): 35mm x 31mm x17mm

Radio frequency: 315MHz

Operating voltage: 12VDC (For example with a 12v v23ga battery)

Transmission distance: maximum 100m

Compatible with 315mhz controllers with 2262, 2260 or 1527 chip

Be careful, it comes with a single remote, although two appear in the photo.

Functioning:

How to copy a new remote: Press and release the only button on the receiver. The red LED flashes and then press the remote control that we want to record.

How to delete all the recorded remotes: press the only button on the receiver for 3 seconds. When the led turns off for the first time, the memory will be clean.

How to change the working mode: On the back of the electronic board, there is a rectangle that says "T" (fixed bistable). You have to bridge the two points, soldering them. From the factory it comes unsoldered, in momentary mode.

Note, you can change the working mode or do a memory clear, but the changes will not work until the power is turned off and on again.

Manual in English, but very simple to program the controls. Even so, if you don't understand, we can help you, ask for Eliseo in our store.