*Offer not combinable with other promotions and for a limited time.
*Offer valid only on our website for orders for Peninsula, Balearic Islands and Portugal.
Jumper cable or clamps (300 Amp)
300 amp jumper cable set.
The length of the cables is 2.2 meters.
Ideal for 6V, 12V and 24V cables.
With ergonomic handles.
Procedure to correctly use the starting clamps:
Turn off the engine of both vehicles.
Turn off all energy consumers (such as radio, heating, air conditioning, etc.).
1: Attach the red wire to the + pole of the empty battery
2: Connect the red wire to the + pole of the good battery
3: Connect the black cable to the full battery pole.
4: Attach the other black clamp to the GROUND of the faulty vehicle, for example, a metal part of the engine or a part of the body.
Start the car engine with a full battery.
Let the engine run at a slightly higher speed.
You can immediately try to start the vehicle's engine or wait a few minutes.
If the vehicle breakdown has been successful, wait a few minutes before disconnecting the jumper cables.
A voltage spike may occur when disconnecting the jumper cables.
